All Articles Review
Review: Roland System 8 AIRA Plug-Out Synthesizer
Rishabh Rajan on Mon, November 7th | 1 comments
The Roland System 8 plug-out synthesizer promises a vast palette of sounds, improved ACB, 8-voices & 3-oscillators with filters and effects. Is it the powerhouse synth you are hoping for?

Roland has added yet another product to the plug-out series of synths and this time it is a lightweight 49-key, 8-voice synthesizer, the System 8. If you are familiar with the System 1 or the System 1m, you will know of the Analog Circuit Behavior (ACB) Engine used in these synths. Yes, it is not real analog but it is one of the nicest sounding circuit modeling technology available on a hardware synth. Let's look at some of the key features on this synth.

Oscillator Section

The System 8 has 3 oscillators, 2 main ones and a very flexible Sub-Oscillator. The two main oscillators have a variety of waveform options, from the usual, sawtooth, pulse, triangle to more esoteric vowel and FM capable wave shapes, to even a cowbell. Depending on which waveform you choose, the ‘Color’ dial will let you modify the tonality. Aside from the usual octave and semitone controls, you also get Cross Modulation, Ring Modulation and Oscillator Hard Sync functions. There’s a modulation selector dial for the 2 main oscillators that can be set to any of the envelopes, LFO or even oscillator 3. When using any of these modulators the color dial sets the modulation depth.

The Sub-Oscillator can be set to sine or triangle and can be 1 or 2 octaves below OSC 1. It too has a color control and a fine tune control. So a lot more than just a Sub-Oscillator, hence the name OSC 3/SUB OSC.

Mixer Section

Aside from the expected level control for the three oscillators, you also get a level control for a noise generator that can be set to white or pink.

Filter Section 

The main filter can be in low pass or high pass mode with cutoff and resonance controls. Both modes have the option of 24 dB/oct or 18 dB/oct slopes. The Filter is a resonant filter, you can turn down the level of the oscillators and crank up the resonance to hear the self-oscillation of the filter. You get controls for velocity sensitivity, key tracking and bi-polar envelope modulation depth control. The filter envelope has four sliders for the basic ADSR controls. In addition to the main filter there is a non-resonant high-pass filter which is placed before the main filter in the signal path.

Roland System 8 AIRA synthesizer

Amp Section

The amp section has four sliders for the ADSR controls, a velocity sensitivity control (separate from the velocity sensitivity control on the filter section), a Tone dial to brighten or dull the overall sound and a patch level control (Separate from the synth volume control).  

Effects Section

You get three separate effects, each having different modes and two dials to control parameters. The first effect has a variety of distortion modes and a phaser mode. The second effect can be set to a delay, auto-pan, two chorus algorithms, a flanger or a dual delay+chorus mode. The third effect is primarily a reverb which can be set to ambience, room, two types of halls, plate and my favorite, pitch modulation reverb mode.

 

Modulation Options

Aside from the built-in modulation options in the oscillator & filter section, you get an LFO that can be assigned to modulate overall pitch, filter cutoff & amplitude. You also get a dedicated Pitch Envelope with just Attack & Decay controls. 

Performance Options

The System 8 has an arpeggiator, Chord Memorizer and a Key Hold mode for hands-free operation. There’s also a 64-step polyphonic sequencer with real-time recording as well as step record options. 

Similar to the classic Jupiter 8, the System 8 has a dual part mode which splits the 8 voices into upper and lower parts, each with a 4 voice polyphony. You can select either of the two parts, have them setup completely different from each other & layer them together or even set keyboard splits for the two parts.

System 8 also features a vocoder mode.

There is also a vocoder mode which uses the audio input as the modulator and the synth sound as the carrier. Unlike most vocoder synths, the mic input is not a XLR but a TRS jack. This is primarily because the input can be switched from line level to mic level, so you can plug in a line level signal and process that with the internal filters and effects.

Plug-out

The System 8 comes with three plug-out slots, two are already pre-loaded with the Jupiter 8 and the Juno-106 model. As of this writing the Juno-106 model is not available. 

The Jupiter 8 plug-out is my favorite feature on this synth, as it is so much better than the Boutique series JP-08 which limits you to just 4 voices. The presets on the Jupiter 8 plug-out sound fantastic. When switching to this plug-out you will notice some of the synth controls are disabled to match the features on the original Jupiter 8. For example, you do not get to use the dedicated AD Pitch Envelope, but the amount control on the Pitch Envelope will control how much the Filter Envelope modulates pitch.

Connectivity

Aside from the 1/4 inch outputs/inputs & headphone output, this synth also has Analog CV gate and pitch outputs, and a trigger input. The pitch CV only works in the volt/oct range & not Hertz/Volt. You get 5 pin din MIDI connectivity as well as USB MIDI. You can also use the USB connectivity to record the audio output of the synth directly to a computer (driver installation required). There’s an SD card slot to save and load presets. There’s also MIDI sustain pedal and expression inputs.

Conclusion

The System 8 is a lightweight powerhouse of a synthesizer. If you can look past the fact that it's not a real analog synth, it is quite competitive in today’s highly saturated synth market. The fact that it can host other Roland synth models makes this much more versatile than most true analog synths. I would generally not pay heed to digital synths as they don’t really live up to my personal expectation but the System 8 is definitely beyond your average digital synthesizer. Thanks to the ACB modeling, it has analog character and thanks to the Plug-out technology that character can be changed on the fly. If this synth was $500 cheaper, it would be a no brainer. 

Price: $1499

Pros: Lightweight, 3 Plug-out slots, high quality analog modeling

Cons: Expensive

Web: https://www.roland.com/us/products/system-8/

 

Comments (1)

You must be logged in to comment. Login Now

  • waluburggmailcom
    Habe heute diesen phantastischen Synthie gekauft und bin absolut begeistert von ihm. Entweder erfülle ich die gestrengenen die Regeln der Synthie - Puristen nicht oder es ist sonst Hopfen & Malz verloren. Womit ich, nota bene, ausgezeichnet leben kann. In n meinem Maschinenpark stehen die Gerätschaften in bester Laune durcheinander, sie kommen oft in verschiedenster Kombination zum Einsatz, und ich habe an jedem,meine helle Freude. Wir veranstalten aber auch regelmäßig immensen Spass miteinander, und da ist nix, was irgendein Wässerlein zu trüben vermag. Leicht mitleidig blicken wir auf die armen Unzufriedenen, die immer etwas zu bemänhaben. Ich bleibe dabei: Der Roland SYSTEM-8 ist eine ganz tolle Maschine. Ich möchte ihn nicht mehr missen, genauso wie die Waldorf's, die Korg's, Moog's, Yamaha's, Arturia's, Novation's, Teenage Engineering's...und alle, die hier nicht aufgezählt wurden. Synthesizer sind eine überaus wunderbare Sache, ich möchte keinen Augenblick mehr sein ohne diese erfreulichen Zeitgenossen. Zweifelsohne eine der besten Erfindungen aller Zeiten!
    • 11 months ago
    • By: waluburggmailcom
    Reply
Feedback
Course Advisor
Don't Know Where To Start?
Ask A Course Advisor
Ask Us!
Copy the link below and paste it into an email, forum, or Facebook to share this with your friends.
Make money when you share our links
Become a macProVideo.com Affiliate!
The current affiliate rate is: 50%
Classes Start Next Week!
Live 8-week Online Certification Classes for: