Hi Guys yesterday i try to control NI Kontakt tune parameter from logic pro 9 via automation, all went ok i assign controller in NI kontakt find that controller in logic kontakt automation ,select marque tool crated 4 automation points and try to set it up down to 7 semitones and here is my problem :i could not adjust the parameter or automation data to -7 semitones it is always 6,40 or 7,20 i click on automation data and try to hold ctrl for fine tuning but they only jump to strange numbers and i cannot adjust them to whole numbers like 3 or 7 or so i always have some like 4.40 and so on .not so sure why is this happening .do you have some idea ? thanks .

Hi Bit late, but did you find a solution to this very irritating problem ??? Cheers